Finally, turn the switch back to ON – the light should stay off if the reset was successful.Allow the warning light to stop flashing, then turn the switch to OFF and wait 5+ minutes.Repeat this sequence 2 more times, ending in the ON position.As soon as the light starts flashing, turn the switch back to OFF.Turn the ignition switch to ON and watch for the initial airbag indicator bulb check.However, we strongly advise using a scanner for the best results. If you do not have an OBD2 scanner available, there are a few manual methods that may reset the light in some vehicles. How to Reset an Airbag Light Without a Scanner Drive for 10+ minutes and verify the light stays off to confirm successful repair and reset.This should turn the airbag warning light off.Finally, use your scanner to erase all stored DTCs from the airbag module computer, then reset the system.Without properly fixing the problems first, resetting the light will only result in it coming right back on. Resetting crash fault memories using a scanner.Installing new airbag system components.
With codes in hand, you can now make any repairs needed to address the identified issues. Refer to your vehicle repair manual for code definitions.
Some standard airbag-related codes include:
